ALTRACO ELECTRONIC DISC BRAKE CALIPER Manual de Serviço descarregar pdf (Página 11)

11. Technician A says that a rough cut should be used to

remove a small amount of metal from the rotor.

Technician B says that a rough cut should not be used

to make a final finish on the rotor surface. Who is

right?

(A) A only.

(B) B only.

(D) Neither A nor B.

12. The cutting depth is set by the ______.

(A) cutter feed

(B) speed feed

(D) cutting bits

13. Hot spots are caused by __________ overheating.

(A) brake

(B) lathe

(D) swirl grinder

14. The swirl grinder puts a non-directional finish on the

__________ surface.

(A) pad lining

(B) rotor

(D) Both A & B.

15. When would the technician want to use an on-car

rotor lathe?

(A) When the rotors are too hot to remove.

(B) When the bench lathe is being used.

(D) On a non-drive axle only.

Chapter 13 Disc Brake Service 229

230 Auto Brakes

A drum brake assembly used on a smaller car. The solid anchor at the bottom always indicates a non-servo brake assembly.

1 2 ... 6 7 8 9 10 11

Sem comentários

ALTRACO ELECTRONIC DISC BRAKE CALIPER Manual de Serviço Página 11